You undoubtedly already know it’s not cheap to heat a pool. The cost of maintaining a pleasant temperature for the 10,000 gallons of water in the average pool is substantial. The good news is that a do-it-yourself solar pool heater is an option. They’re simple to produce, effective, and economical to run. To know more, check out https://swimmingvac.com/hayward-pool-heater-ignition-failure/
While conventional solar water heaters store hot water in a tank until needed, a solar pool heater circulates the water continuously. Therefore, you should modify the layout to speed up the healing process for the water.
Expose as much of the water’s surface as possible to speed up the healing process. This is because more solar energy will be absorbed if a larger area is subjected to direct sunlight.
This is why numerous do-it-yourself solar pool heater designs function in the same fundamental way. Think of a hose used to water a garden. The water in the hose can be heated by exposure to sunlight. The theory is that more water can be heated if the hose is longer.
Based on a pipe coil concept, this DIY solar pool heater is cheap and easy to build. It operates similarly to the coiled garden hose described above.
Where to Put Your Do-It-Yourself Solar Pool Heater and Why
You have two options when deciding where to put the solar pool heater. To maximize solar exposure in the northern hemisphere, position your garden so its southern face faces the sky. If nothing of those options works, you should meet east or west. It should be pointed northward if you are located in the southern hemisphere.
First, you can put it on the ground if you have a suitable area with enough sunshine throughout the day. The efficiency of your solar pool heater will naturally decrease in the presence of shade. In most cases, installing it on the ground is the simpler alternative because less plumbing is required.
The second option for those limited in square footage is installing it on the roof. When seated at a greater height, solar water heaters are less likely to be disrupted by shade and blockage.
Methods for Constructing Your Own Solar Water Heater
You may be pleasantly surprised to find out that this is quite simple. 500 feet of 10mm black irrigation piping, valves, and additional plumbing to connect it all will do the trick.
Once you have these materials, wrap the piping tightly around itself while maintaining a flat profile. You may need to use some hardware to keep the coiling in place after you’ve secured it. Since the water will flow through the pipes and into and out of the pool heater, you should ensure that both ends can be easily accessed.
Installing a Solar Pool Heater Yourself
This is not a challenging task once again. The solar pool heater is easily installed in series with the pool pump. This will help you keep the water moving. In addition, you may bypass your water heater at any time by installing a T valve between the inlet and outlet lines. After everything is finished, you can connect the heater’s pipes.
Once the plumbing is set up, the water being pushed from the pool into the heater will be warmed by the sun as it travels through the pipes. After being heated, the water will be pumped back into your pool.
DIY Solar Pool Heater: Some Food for Thought
Despite this, there is still one more factor to consider: the friction the water creates as it flows through the pipes. A maximum piping length can be used before the resistance from the line becomes too much for the pool pump to overcome. If this occurs, the pump cannot circulate the water effectively.
Aside from that, you’ll find that constructing your do-it-yourself solar pool warmer is surprisingly simple. It’s a cheap option for keeping your pool warm and increasing the number of months you can spend each year with your loved ones.
Read Also: 7 Reasons Why ERP Systems Fall Short
